EQ2Bot

[MTBR]

Ok I map out a section using navigation with multiple pull spots. I than hit start but the current action says Idle and it does not move or pull mobs. If i engage a mob it will continue actions including looting mob after death. Any suggestions on why it wont move and pull mobs?

 

[clogue77]

Ok I map out a section using navigation with multiple pull spots. I than hit start but the current action says Idle and it does not move or pull mobs. If i engage a mob it will continue actions including looting mob after death. Any suggestions on why it wont move and pull mobs?

Under the tab "EQ2Bot Options" you should see three slider bars. Set your "Scan Range for AH" to something like 50 to see if that moves your bot. I usually set my "Out of Range Reaction Distance" to one over the Scan Range. Though I don't really know what that does, but it seems to work for me.

Make sure you do not have any mobs on Ignore. To check this go to the "Ignore" tab and make sure all of those are unchecked except for the Grey mobs setting.

Hope this gives you a starting point...