ATM i discovered following bugs in ratter

andrey

Active Member
evebot cant recognize localchat players, so black/white list become pretty useless.
evebot count bounty incorrectly. for example they list basic BS bounty properly, but total calculations of resp bounty always shown as zero.
 

andrey

Active Member
Say please when will correct not correct work of the program related to escape from belt, a ship does not escape at appearance of alliance indicated in a black sheet!!!
 

RedMan

Active Member
This works for me.. but from your english I'm guessing you might be using it wrong...

You should only have ONE of "warp out on whitelist" or "warp out on blacklist" checked.

Blacklist would be for mining in high-sec to hide when a corp/individual that is hostile (perhaps wardec'd) comes into system. It will tolerate any unlisted folks in system.

Whitelist is for 0.0 when you want to hide from EVERYONE but the good guys. Your corp and alliance are automatically whitelisted so for many folks just checking on this and leaving the default whitelist is fine. If you have corps set to blue but not in your alliance and you want to trust them... that is the time to add to the whitelist.

Never use both!
 

andrey

Active Member
Whitelist is for 0.0 when you want to hide from EVERYONE but the good guys. Your corp and alliance are automatically whitelisted so for many folks just checking on this and leaving the default whitelist is fine. If you have corps set to blue but not in your alliance and you want to trust them... that is the time to add to the whitelist.

Never use both!
Say please what kind has your black or white list because created by me a white list renounces to work :(
 

andrey

Active Member
explain please how to make a white sheet, if it is possible set the pattern on the prepared white sheet
 

RedMan

Active Member
uhhhhh.

It creates a template whitelist for you. Fill in where obvious....

Lets assume you are in 0.0 and want to keep on ratting when members of your alliance are in system rather than hiding at safe spot.

Step 1: delete the current charname_whitelist.xml from your config folder
Step 2: start evebot and select to hide on non-whitelisted

Thats it... it assumes your corp and alliance mates are good guys.

Now more complicated... you want to keep on ratting while certain friendlies are around who are NOT in your alliance.

Run steps 1 and 2 to generate a clean template charname_whitelist.xml file in your config folder.

Step 3: keep running and while it is hiding, it will be spamming to the console some messages. You need to decide whether you want to whitelist just this pilot, their whole corp, or their alliance. Write down the pilot id, corp ID, or alliance ID as you decide.

Step 4: STOP evebot

Step 5: add a line to either the pilot, corp, or alliance section of the charname_whitelist.xml file matching the example line. The name is IRRELEVANT, it's the ID that matters, enter it where the "0" is in the example line.

Step 6: start evebot, everything works.

I'd post an example but I'm at work here.

EDIT: I forgot Step 0, wait for ISXEVE/Patch chaos to be over :p
 

andrey

Active Member
Thank you very much for explanation but whether it is impossible to rotin on an example as a white sheet is filled?
 
Top Bottom