entry point invalid and kernel wont load..

[zarina3231]

everytime I try to load through innerspace I keep getting the procedure entry point blah blah could not be locat3d in the dynamic link library isui.dll and then the message could not load kernel. any help please?

also uninstalled and reinstalled more than once thanks.

 

[Kannkor]

everytime I try to load through innerspace I keep getting the procedure entry point blah blah could not be locat3d in the dynamic link library isui.dll and then the message could not load kernel. any help please?

also uninstalled and reinstalled more than once thanks.

You're aren't properly uninstalling.

Check the following folders and make sure you delete any ISXEQ2.dll files. They could be in ANY of these directories.
innerspace/
innerspace/extensions/
innerspace/extensions/ISXDK34/

Once you've done that, before you install again, try to load isxeq2, if you get the same error as above, then you missed deleting one. If you get not found, then go ahead and install, and try again.

 

[zarina3231]

You're aren't properly uninstalling.

Check the following folders and make sure you delete any ISXEQ2.dll files. They could be in ANY of these directories.
innerspace/
innerspace/extensions/
innerspace/extensions/ISXDK34/

Once you've done that, before you install again, try to load isxeq2, if you get the same error as above, then you missed deleting one. If you get not found, then go ahead and install, and try again.

I completely uninstalled and did a search and deleted anything and everything that had isxeq2.dll still get the same message. I have no clue what I'm doing wrong..

 

[zarina3231]

I would greatly appreciate a teamviewer session if and when someone can help me with this situation. I've been at it for hours... Thanks in advance

 

[Amadeus]

Send an email to amadeusmq@yahoo.com with your teamviewer ID/pass and I'll look at it. It will be at odd hours most likely, so be sure to leave the computer on and I'll do it (probably VERY late at night.)