Looking for better heal performance from Ogre

E

eclipsed

Member
Currently using Ogre with a Mystic. At times I notice that it just won't concentrate on healing like it should. Currently am using the Mystic setup from the faq page on the wiki. I do have it setup to melee and debuff, but I removed a lot of that stuff from the setup and kept the CA's/debuffs it uses to a minimum. I also use the priority tab for emergency skills and combat tab to maintain the single and group wards constantly.

What I am noticing is that most of the time during periods of heavy damage it just won't heal my tank effectively at all. There are times that my tank will end up in the red for extremely long periods of time, sometimes indefinitely and the only thing that saves it is the fact that I run a pally and can cast some decent heals of my own.

Just wondering if there is something I am missing that is causing the mystic to not heal.
 
bjcasey

bjcasey

ISX Specialist
I would wait until Kannkor releases the next version of the bot because it will come pre-loaded with a mystic profile.

That said, are you running the mystic as a solo healer? What group setup are you using? What is it casting that you don't like?
 
E

eclipsed

Member
Yes, running it as a solo healer. Pally, dirge, assassin, coercer, mystic. Most likely adding an inq which will probably provide coverage for the times when the mystic fails to heal. However would like to know what I am doing wrong so it doesn't happen again.

It does constantly cast the wards, cast cures (though often not as fast as I would like), and does use the group heal. Group heal being the strange thing as that is setup on the heal tab along with my other heals and is my middle percentage. Same as the faq setup for Primalz. But it will cast Rejuvenation or Ritual only very rarely and mostly only out of combat. It also does not cast my emergencies very often that are setup on the priority tab. It will mostly just use the CA's and roll the wards.
 
Kannkor

Kannkor

Ogre
eclipsed said:
Yes, running it as a solo healer. Pally, dirge, assassin, coercer, mystic. Most likely adding an inq which will probably provide coverage for the times when the mystic fails to heal. However would like to know what I am doing wrong so it doesn't happen again.

It does constantly cast the wards, cast cures (though often not as fast as I would like), and does use the group heal. Group heal being the strange thing as that is setup on the heal tab along with my other heals and is my middle percentage. Same as the faq setup for Primalz. But it will cast Rejuvenation or Ritual only very rarely and mostly only out of combat. It also does not cast my emergencies very often that are setup on the priority tab. It will mostly just use the CA's and roll the wards.
Click to expand...
Yea, best advice I can give is wait for V15. I don't think any of us see this type of behaviour, so something is set up incorrectly. One thing to remember, is he will only cast things on the heal tab if that target (or if set to group, anyone in the group) is at that health or below. If not, there is no reason to heal. Either way, there will be a mystic default profile with v15.
 
pz

pz

Active Member
i havent used my mystic in months (running solo inq lately), and like you say its very possible the inq was masking faults in the mystic all along, but if nothing else try adjusting the percentages, the order etc. sorry! :(
 
xbit

xbit

Well-Known Member
insanitywiz said:
Until the new version is out, move away from using the heal and cure tabs, and put that stuff in the priority tab.
Click to expand...
This is what I did as I noticed a slight logic lag in healing after Priority was released. It was more noticable with sub 50 healing classes. All my healing is done in the Priority tab now.
 
You must log in or register to reply here.
Top Bottom