Been using ISXEQ2 bot for years. I stopped using it a few months ago mainly because all I did was raid SF on my primary toon. Has always worked good for me.
Now that DOV has been released I fired up my toons again and EQ2 Bot is up and running like it always does but the toons aren't acting as they should. I'm getting a lot of weird DEBUG messages when you look at the command line. For example:
DEBUG: EQ2BOT-ValidActor()::No Line of Sight to xyz Mob
Note this happens on just about every mob I fight in any zone. If I move the bot around and hop him up and down eventually he might start attacking. After some time though he cant hit anymore and stops casting because he goes right back to the same error message.
Basically my bots are having a hard time engaging.
Now that DOV has been released I fired up my toons again and EQ2 Bot is up and running like it always does but the toons aren't acting as they should. I'm getting a lot of weird DEBUG messages when you look at the command line. For example:
DEBUG: EQ2BOT-ValidActor()::No Line of Sight to xyz Mob
Note this happens on just about every mob I fight in any zone. If I move the bot around and hop him up and down eventually he might start attacking. After some time though he cant hit anymore and stops casting because he goes right back to the same error message.
Basically my bots are having a hard time engaging.
