Set Up For....

Y

Yorkie

Active Member
I have made a new guard tank and the command for the names "set up for ..." doesn't seem to work. I have been using my SK on the same account for quite a few years with no trouble at all and checked all the settings with this new guard but the command for the names just wont work for some reason.
Any ideas plz??

Guard and sk are on same account, and using ogre with raid and grind options enabled. btw

thx
K...........
 
L

loopy

Member
check move to area if the set up for is moving the tank for you. Also make sure Grind options and raid options are checked.
 
Y

Yorkie

Active Member
yep all those are selected, if I swap to my SK using the same group and all the settings a re the same it works great, swap back to my guard that's on same account as SK and it doesn't work
 
Y

Yorkie

Active Member
Both, no one goes into position, but when I swap to my sk everyone moves ok, so it's a setting somewhere with my guard I think but all settings look the same as my SK. Gonna have another look see if I can sort it tonight when I get in.

Thx k.....,
 
C

Cheesy

Well-Known Member
Sounds like your guard isn't listed in your EQ2Chars, so nobody will follow it's commands...
 
Y

Yorkie

Active Member
forgot to close this off and hope it helps other with same problem, but thanks Cheesy it was that and it works a treat now, noob error on my part just been so long since a made a char I forgot to list it in EQ2chars.. thx again

Regards
K..........................
 
You must log in or register to reply here.
Top Bottom